High/Low Pass Filter Calculator

A high-pass filter (HPF) also known as "Bass cut" is an electronic filter that passes high-frequency signals but attenuates (reduces the amplitude of) signals with frequencies lower than the cutoff frequency.

A low-pass filter (LPF) also known as "High cut" is a filter that passes low-frequency signals and attenuates signals with frequencies higher than the cutoff frequency.

A low-pass filter is the opposite of an high-pass filter. The actual amount of attenuation for each frequency varies depending on specific filter design. Using the high/low pass filter below this attenuation will be +/-3db. The calculator is based on the formula:

f = 1/2*Pi*R1*C1

Enter a value in 2 of the fields and click Calculate.

Capacitor (C1) :     µF
Resistor (R1) :     Ω (ohms)
Cutoff frequency (f) :   Hz
   

Enter DoitFuzz.com Forum Board DoitFuzz.com Forum Click here • Still not a member ? Register Now it's Free!
Home • Forum • Join DoitFuzz • Login • FAQ • Fuzz Wiki • Links • News • Help / Support • Contact • Twitter 
[ Capacitor Conversion Chart ] • [ Resistor Color Code Calculator ] • [ Voltage Divider Calculator ]
[ Ohm's Law Calculator ] • [ Non Standard Resistor Calculator ] • [ High/Low Pass Filter Calculator ]
[ Op Amp Gain Calculator ] • [ Series/Parallel Resistor Calculator ] • [ Series/Parallel Capacitor Calculator ]
[ Led Resistor Calculator ] • [ Big Muff Bias Resistors Calculator ] • [ Fuzz Face Bias Resistors Calculator ] • [ Webchat ]

Copyright © 2022 doitfuzz.com